Vibrator for concrete - equipment widely used in modern construction for compacting concrete mixtures. They are used both on large construction sites, and when erecting low-rise buildings. After that, How did you decide to buy a concrete vibrator for rusvibro.ru, need to figure it out, how to work with him further, To maximize all the capabilities of this equipment and get a good result.
Each type of vibrational equipment has its own requirements for operation. The deep vibrators have a vibration infinite, which is immersed directly in the thickness of the concrete solution, And a flexible shaft. Respectively, The vibration inflammation depth depends on the length of the shaft.
If you are building a small building, cottage, then enough shaft to 4 m. For large construction work, the length of 6 to 10 m. Besides, it is necessary to choose the correctly and the diameter of the vibration inferior, tk. In the course of work, it is possible to contact him with the armature, which is undesirable. To avoid this, you need to choose the tip with thickness at least on 1/3 less, than the distance between the rods. The tip should also not come into contact with the walls of the form, respectively, The distance between it and the formwork should be at least 10 cm. To achieve the optimal result, the tip must be immersed in the mixture at least, than every 60 cm.
If you purchased a new vibrator, It is necessary to collect it. To do this, connect a flexible shaft at one end to the vibration endo, and others to the engine, Seal the joints with a protective tape or sealant and attach the shaft armor. Then it is necessary to check the vibrator for serviceability and the presence of possible damage and start the test mode. Then the trial launch. To do this, you need to install the device out of the blue and not very much hit the tip along the formwork wall, In this case, vibration should appear. If everything is all right, You can start work. With the time, withstand time, set according to the instructions, and the distance between the diving points of the shaft.
Working with a surface vibrator is distinguished by the topics, that it must be fixed on the work surface. Supports are screwed to the base of the vibrator using bolts. Before starting work, the device must be grounded and adjusted, Giving the necessary position with the lids of the debans. Besides, through 5 minutes and 1 an hour of work, it is necessary to tighten the fasteners. So they do not shatter and will not fall out, and the vibrator itself will fit the work surface as tightly as possible, which will ensure the best result.