The wiring project is one of the elements of construction documentation. Must contain the main parameters, Technical solutions and installation scheme. It happens very often, that the installation plan is prepared without the participation of its future users, and then with their participation changes. Sometimes, Corrections are so big, that the wiring in the house has to be designed again.
Wiring circuit in the house
The electrical equipment project must be drawn up in accordance with the technical rules. However, in order to properly arrange the lamps, sockets, and plan a route of electric cables, The specialist must have access to the project of the future interior. If not accurate, then at least approximate.
He must know, where in the dining room there will be a table, To provide a place for lighting above it, as well as the location of the TV, computer or music center, requiring access to socket connectors.
During the work, it is necessary to adhere to the installation project, and apply possible changes to drawings. Knowledge of the system of electric wires, invisible during wall decoration may be useful in the future during the operation or repair of the house. You can order all the necessary electrical equipment with delivery on the site Complect-Service.ru.
Electric circuits
Electrical equipment is connected to the supply circuit to the groups of sockets, lighting points, as well as individual devices requiring power (usually with high power or special meaning: washing machine, hydrophor, Central heating boiler, Electric water heater, pump, etc.. d.). In accordance with the rules in one chain, there should not be more than ten sockets of sockets or 20 light points.
Each circuit must be separately protected in case of short circuit or overload. Electric installation in individual residential buildings should be made with a margin, for example, in separate rooms under plaster, you can place additional tubes, into which it will be possible to draw a cable in the future.
The number of sockets and light points is not in a particular way limited – but there are recommendations of which should be followed. Excessive saving on wiring can lead to that, that the installation will not be functional. An exaggeration to the other side will unreasonably increase the cost of installation and auxiliary equipment, and can also lead to unnecessary introduction into the walls of switches and connectors. If you want to have a lot of them, more chains need to be provided, In order not to lead to their overload. The load of a single -phase circuit should not exceed 2 kvt, three -phase - 6 kvt.
Electric circuits must be laid in a straight line along the edge of the walls. Then their restoration will occur faster, Based on the placement of distribution boxes.
