Modern laminate is produced using technology that allows self-installation. This does not require additional complex technical devices.
This is how laminate differs favorably from parquet, which is laid using special equipment.
Laminate is joined end to end, without the use of additional funds.
After purchasing a new laminate flooring, you should leave it in the room for a few days.. This is done to acclimatize the material.. Once the flooring has completely adapted to moisture and temperature, you can begin installation..
To carry out such work, preparation is sufficient.:
- Wood block;
- Small hammer;
- Spacer wedges;
- Regular pencil;
- "Z" shaped clamp.
Laying is done in a row starting from the far wall. If you lay the covering in rows perpendicular to the window, the light will not highlight the seams between the rows, and the entire floor will seem more complete.
Laminate must be laid on a moisture-proof base. If this is not done, moisture from the concrete base will penetrate into the floor covering and it will “swell”, after which the expensive floor will have to be completely replaced.
I lay regular laminate on polyethylene foam. This base provides additional protection against mechanical loads..
In stores you can also find laminate with a soft base.. Lay it on a regular thick plastic film.
Choosing a wall, from which you will start styling, first install gap bars one centimeter thick. This is necessary so that the laminate has room to expand during the wet season. Remove the bars only after laying the entire surface.
The covering is installed in full rows, which are connected to each other by a special groove. Different manufacturers may use different types of grooves. For more details on how to connect a specific type of coating, see the packaging..
Connecting individual plates, Do not hit the hammer directly on the surface, be sure to use a special bar. A good option would be a block with a groove cut out like a laminate, using it, you won't damage the connections.
[alert-success]The slabs must be installed tightly and without gaps. If it so happens that you missed a gap, don't despair, disassemble the laid surface and start again.[/alert-success]
The plates should be connected in a checkerboard pattern, so that the seams overlap each other.
Video about that, how to choose and lay laminate flooring with your own hands
By following these recommendations, you can easily install a new floor in your apartment.. Follow the technology exactly, and this flooring will serve you for many years.
