Features of Kastor bath stoves as follows:
- Stainless steel structural body: thick oven walls 5 mm, and the upper part of the stove 8 mm. As a result - long service life; economical and environmentally friendly, through the use of zapotentovannogo by CONDA effect (full fuel afterburning), step-up efficiency sauna stoves 70 % (burning one bookmark wood 4-5 diameter logs 8-10 cm allows you to get the temperature 100 degrees Celsius in the calculated volume of steam);
- capacious stone compartment (to 100 kg) makes it possible to get good soft steam, and the separation of the furnace chambers and stones readability allows water on the stones in the furnace combustion process;
- the presence of the glass door enables tracking stage combustion of wood, while enjoying the "game live flame fire".
for KASTOR bath furnace wall from a natural stone and serpentine talkohlorit (coil) – this is:
- maximum humidification in the best traditions of the Russian bath, creating fine enveloping light steam, which does not lead to overdrying warm air.
- pleasant heat throughout the sauna – from floor to ceiling, allowing steam to the lower shelves.
- the ability to control the air flow in the steam room (convection) eliminating overheating steam or vice versa, heating it to a state of dry air sauna.
- Castor furnace exit (Kastor) to hover over all operating conditions 1-2 o'clock.
- sturdy and durable cladding construction (dry assembly without cement works and special foundations).
- Compatibility with ceramic chimney systems of new generation Schiedel UNI.
furnace bath Castor (Kastor) and the chimney Shidel Uni rationally takes in the steam room 1 m2, saving space and money. - increased heat capacity of stone cladding (in 2.5 times greater than that of kiln bricks) It allows you to replace the small amount talkohloritnogo three-ton stone Russian stove;
healing thermal radiation of talcahlorite and coil increases immunity to various infectious diseases, It regulates blood pressure, heals the respiratory system, improves metabolism.
As to heat the furnace to correctly bath Kastor
It is necessary to melt furnace, with wide-open the ash pan and a fully open chimney, finely chopped kindling. At this moment on 4-6 See, you can open the ash pan. After that, as the first tab burned firewood, the next tab should not 2/3 filling the furnace grate on top. Combustion occurs more effectively, when there is a free space above the wood. Interval podkladyvaniem wood depends on the species, thickness and moisture content of wood, and of course in the furnace by rods, typically, this interval is 20-30 minutes. To improve the heat transfer from the stone in half, cover the chimney damper, and it is possible to 2-3 See slide valve slot. Firewood lay a better, when the furnace coals were, flame should extinguish. If the furnace tube about red-hot to red, do not enclose the wood, but rather the chimney slightly open for more than a half, and reduce the amount of wood.
With proper selection of the furnace for the bath, the oven can be brought to the operating time through 1-1,5 o'clock. Usually the easiest and soft steam at the end of, when the coals burn out, and the stones are not overheated, and uniformly warmed.
Usually, in the bath is very rarely done forced ventilation, so open the window or hood to dry flat, and toss 3-4 logs into the furnace. Kastor bath stoves are mostly fired with wood, optimum length of the log 33 cm. Directly above the grate must burn wood, in any case in tunnels. Wood is better to use dry, raw wood give more smoke, and part of the energy goes to the evaporation of moisture and well certainly increased wood consumption.
